General information
Category:
ActiveX controls in VFP
Claudio,
>Is strongly recomended to you, upgrade your service pack 2 to 5.
>
>..And use the TREEVIEW SP4, is more useful then SP2 and they fix a lot of little problems.
Thanks for the response. I tried using the TreeView v. 6.0 SP4, but it still does not work. It appears that the treeview's OLEDragMove does not fire when the form is compiles into either an APP or EXE. The form works fine in development mode. Also, I tried issuing the SYS(2033,0) to turn off dual ActiveX support, but ... you guessed it ... no dice.
I knew that this phase of the project was going too smoothly.
Doug
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only