General information
Category:
Reports & Report designer
See my last reply to Cindy. I did set the default font before drawing any controls, and checking the font settign of each control shows it is indeed the same as the font I picked for default font. Maybe I'm mistaken in my assumption that on an Epson LX-1050 printer, Draft 17cpi is a compressed fixed width font? I thought the Roman and Sans Serif fonts were the proportional ones on an Epson dot matrix printer.
>
>Did you set the default font before or after you designed report? The controls on report pick up default font only when there'are created. Changing the default font doesn't affect existing controls.
>
>
>It's strange. It should look aligned in development too.
>
>
>Check Page Setup, particulaly Columns With. It will give you an idea what margins are.
>
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only