>Hi Matthew,
>
>Have you tried to put:
>
>sys(2333, 0)
>
>into the Load() of the form. See if that helps. I am not completely sure what it does but I had a similar problem and it did the trick.
>
>Good Luck...
>Yuanitta

From our friend the MSDN Library:

If an ActiveX control does not perform properly when the control is instantiated, issue SYS(2333) or SYS(2333, 0) before the control is instantiated to disable dual interface support for the control. After the control has been instantiated, issue SYS(2333, 1) to enable ActiveX dual interface support for any controls that are later instantiated.

Tom