I seem to get the error -
Feature is not available.
whether I put the BUILD EXE command inside of a .PRG program and run it from another .PRG program or run it from a form that has a command button on it that runs the same .PRG program that has BUILD EXE in it.
Where can I locate my BUILD EXE command where I won't get this error? I do a BUILD EXE after I update several .SCX form files that belong to a .PJX project.
Thanks again. I know I asked a similar question last week, but the problem then was about updating a .EXE when other users are using it, but I have remedied that problem.
Steve Kramer
Kramer & Kramer Design
"Home of Go Cartoons"
Web Site:
www.stephenkramer.comWould you believe Far Side Lite?
More than 270 original cartoons.