General information
Category:
Source Safe Control
Title:
Can not update cursor message
Ocaasionally we get a message "Can not update Cursor" while doing a build in VFP6 SP4. In almost every case, we have traced it down to a VCX that is located in a shared tools folder, under SourceSafe control in a project in that folder. As a work-around, we have found that if we set the Read-Only attributes OFF we can do the build ... but we have to make sure that we re-set them back to ON before we do any SourceSafe manipulation.
Does anyone out there have any ideas? Are we doing something wrong ... or have we been bitten by a bug?
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only