The reason I was getting the error is because _pageno must be between 1 and 32,xxx.
I cannot for the life of me get this to work. I set the value of _pageno to 1 and then I check it in the debugger and it is set to 1 however, the report still prints page 3. I have tried to send _pageno as a parameter by reference. It doesn't like the "@" in front of "_pageno". I've tried everything I can think of here.
Any help would be greatly appreciated.
Paul
>Hi Dragan,
>
>I have changed the "on exit" of the location group footer to call a proc in a prg that is available. In the proc I have one line of code. _pageno = 0. When I run it I get an error "Expression evaluated to an illegal value".
>
>Paul
>
>>>I have an frx with 5 data groupings. Data groupings 1 and 2 have the option selected that starts on a new page. Data grouping 1 has the option selected to reset the page numbers.
>>>
>>>The problem is that data grouping 2 also resets the pages even thought I don't have it checked.
>>>
>>>IOW, grouping 1 = store location, grouping 2 = categories. Everytime the category changes I want it to start on a new page but not reset the _pageno. But once we switch to a new store location I want it to begin on a new page and start with Page 1 again.
>>>
>>>Everything starts on a new page correctly..its just that my page# is always 1.
>>>
>>>I have 2 different reports where I am having the same problem. I did a lot of searching on this subject and haven't found anything...so I assume I am doing something stupid here, but I can't figure out what it is..
>>
>>Here's a cheezy and dirty trick, but might work. Create a report variable nPages, set it to zero, calculate nothing. Write a function, name it, p.e. StoreNPages.prg:
>>
nPages=nPages+_pageno
>>(yes, a one-liner), and call that function on exit in category group. Instead of _pageno, print nPages+_pageno. That's it.
>>
>>Or if you are having the oposite problem, that the _pageno is not resetting, and you need it reset, this can work as well, even simpler. Forget the report variable, and just have a function which will set _pageno=0 each time your group exits.
