General information
Category:
Coding, syntax & commands
Clear from memory.
I have 2 exe files. 1 (the main exe) calls the other. As I quit the 2nd exe & command goes back to the 1st exe, looks like (some?) memory variables declared in the 2nd exe did not release. I have quite a lot of memory variables to release from memory, would like to know if I can clear it with a command, instead of clearing by naming them one by one. Cannot CLEAR ALL, since wouldn't that also clear variables in the main exe? The memory variables in the main exe should not be cleared. Any ideas?
Thank you!
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only