General information
Category:
Reports & Report designer
Title:
Breaking a report into regions
Is there anyway using the report designer to do the following? I have three regions on the paper I want to print to. The top needs to report information in my table until two scenarios occur a)no more room to print 3inches allocated b) no more data to print
The second region needs to print information from one record in a table.
The third region needs to pick up where the top region left off and then stop when the a) or b) above occurs
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only