General information
Category:
Coding, syntax & commands
Title:
Message Box Function
This question seems trite in view of some of the other questions I have been reading, however the only dumb question is the one you don't ask, so here goes. When using the messagebox() function, is it possible to change the text on the selection buttons? In addition to that, when I use the messagebox() function, I am experiencing some unusual behaviour. I tried using the following code to produce a message which would show the stop icon, the "YES,NO" button set, and set the focus to the second button.According to the Hacker's Guide for VFP 6.0, the integer should have been as follows:
16 - Stop Icon
2 - Yes, No
256 - 2nd button has the focus. When I use the 274 parameter however, I get the three buttons, Abort,Retry,Ignore showing up. I have tried it many different ways, but with the same result.
Thanks to All
Regards
Carmen
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only