General information
Category:
Reports & Report designer
Hello Paul
I have never had GPF problems with the report writer, it has always been very stable.
Perhaps you are using some features of VFP that are not in very common use (since VFP is such a big language there are many different ways to do each task)
I have found using the SET FIELDS command creates lots of problems, are you using it by any chance?
>I've just had a very unpleasant two hours trying to write a very very simple report that would have taken me ten minutes to do in Access. However I was treated to a veritable fireworks display of GPF's and blank screens (yes I even got a dead black screen..no message..just dead).
>
>It did it anywhere, anyhow. Put a label on...GPF...minimise the window...GPF. It was mad. Is this normal behaviour??? Most of the messages started with C00005 and then gave me the usual 'Your application has just blown up' message.
>
>I'm using W98 2nd ed, VFP 7.0 (with SP1!!). I even switched off the virus guard.
>
>Also, can anyone tell me why the report writer is so limited. Does everyone just go and use Crystal or some other report writer. Just curious.
>
>Pablo
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only