General information
Category:
Installation, Setup and Configuration
Title:
Take a number installation
I'm struggling with a network installation. Using VFP6.0, SP5, nothing special in the config.fpw. Created a set up diskette using the Wizard and installed it on 2 workstations. The exe and data files were copied to the server.
User #1 can access the system OK, so can User #2.But they cannot access the system at the same time. If User #1 is in and user #2 tries, nothimg happens until User #1 exits. The User #2 pops right up. Any ideas??
TIA
Jere Dorough
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only