>I have a report in FoxPro 2.6 which is supposed to print to an envelope feeder on an HP LaserJet Printer. The report worked fine until recently.
>
>I just switched all our printers to be network printers using JetDirect cards and cat 5 wire to connect to our hub and therefore our computer system.
>
>Everyone has the JetAdmin software; the print drivers for the printers are installed and working fine from MS Word and other programs.
>
>When I open the report and edit the "printer setup" under "page layout," I can choose the paper size, #10 Envelope, and I can choose envelope feeder. I then proceed to save and close the file. When I open it again to check the settings, paper size is #10, but the envelope feeder is no longer selected, instead the multi-purpose tray appears.
>
>I have two thoughts. First, there may be a way in code to force FoxPro to tell the printer which tray it is printing to. Second, that FoxPro 2.6 does not support network redirections using the \\HP_NETWORK_PRINTERS\38.17.23.201 syntax for print drivers.
>
>I would appreciate any suggestions.
>
>Take care,
>Jeff
Jeff,
I would do this in the setup for the report.. Send the esacpe sequence that selects the envelope feeder with ??? ..
Thanx!
Tony MIller
Vancouver, Wa
Précédent
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement