General information
Category:
Menus & Menu designer
>I have a menu - one of the menu options is to print a report to screen.
>
>After the user prints a report to the screen, all of the menu pads are enabled (as they should be), and when I select a menu pad, the corresponding sub-menu appears. The problem is that nothing happens when I choose one of the sub-menu pads. This does not happen when I run the app on my C: drive.
>
>The command for the menu pad is:
>REPORT FORM culisting PREVIEW
>
>The problem is not that the report doesn't print to preview - it does. The problem is AFTER I CLOSE the preview window the menu items are enabled (which they should be) but NOTHING happens when I select an item from one of the sub-menus (eg. if the sub-menu pad command is to open a form - nothing happens). Once again, this only happens when I run the exe from thge network - not when I run the 'uncompiled' app on my c: drive.
>
>Has anyone else come across this behaviour?
Allan,
I too have run across this behaviour. It happens as I'm running my app in a Top-Level form with .Application = .F. When I go to preview a report I set .Application = .T. because I can't get reports to preview in my top-level form and when it gets back, often the menu bar is screwed up. I just reissue the DO MENU command and it works fine after that. I haven't read the MS KB article though.
Steve
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only