General information
Title:
SET PRINTER TO NAME (Re-Visited)
I mis-typed my situation on a previous message
so I am presenting this problem again.
I believe that this command sequence does not
work properly. I am wondering if others have
noticed this.
cPrnName = getprinter()
set printer to name (cPrnName)
report form xxx to print noconsole
I have found that the print job goes to the
same printer regardless of the printer I
selected (cPrnName).
This, on the otherhand, works fine ...
report form xxx to print prompt noconsole
Anyone else experience this ?
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only