General information
Category:
Coding, syntax & commands
Title:
Standard Toolbar Issue
Hi,
We just set up a new 2 way server for our foxpro application and installed Foxpro 6.0 on it. We copied the application over to the 2 way server from our 4 way server. When we run the application (exe) on the 2 way server we now see the Standard Toolbar which we don't see when we run the application (exe) on the 4 way server.
I did open foxpro on both servers and noticed that the standard toolbar was selected under view menu on the 2 way server. I deselected the standard toolbar and click the exe again no change, still see the toolbar.
We mapped a drive on the 4 way server to the exe on 2 way server and ran the exe from the 4 way server and we do not see the toolbar. But when we run the same exe on the 2 way server we do see the toolbar.
TIA
Barbara Carracino
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only