Information générale
Catégorie:
Codage, syntaxe et commandes
Titre:
Standard Toolbar Issue
Hi,
We just set up a new 2 way server for our foxpro application and installed Foxpro 6.0 on it. We copied the application over to the 2 way server from our 4 way server. When we run the application (exe) on the 2 way server we now see the Standard Toolbar which we don't see when we run the application (exe) on the 4 way server.
I did open foxpro on both servers and noticed that the standard toolbar was selected under view menu on the 2 way server. I deselected the standard toolbar and click the exe again no change, still see the toolbar.
We mapped a drive on the 4 way server to the exe on 2 way server and ran the exe from the 4 way server and we do not see the toolbar. But when we run the same exe on the 2 way server we do see the toolbar.
TIA
Barbara Carracino
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement