General information
Category:
Reports & Report designer
I very much appreciate your response!!!!!!!!!!!!!!
YES, I have a report where I am going to print address on one side of paper and some small amount of data about that person on back side.
I have a duplex printer for that.
The report breaks and prints a new page on every record so the thought was I could print both sides same sheet.
I tried to just move down to about 16" on 11" long paper (that is about where I would need it).
I think I have to change the paper length and ten depend on the printer to print part of the record on one side then part on back.
I would apprecaite any suggestions!!!
THANKS
Joel
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only