General information
Category:
Third party products
I am having the following error message when closing Visual FoxPro after using the Olympus ActiveX Digital Camera Control:
The instruction at "0x0f0037d4" referenced memory at "0x0f0037d4". The memory could not be "read".
I was able to get all camera functions to work after turning off the ActiveX Dual Interface Support (SYS(2333,0)). However, all attempts at exiting either a compiled application or Visual FoxPro after running the DCC-attached form result in the error above. I did call Microsoft - they suggested issuing a CLEAR RESOURCE command - but that did not work either. I also tried turning the ActiveX Dual Interface Support back on (by itself and in conjunction with the CLEAR RESOURCE command) and that did not work. If anyone has any suggestions they would be greatly appreciated!!!
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only