General information
Category:
Forms & Form designer
Hi Garrett,
The timer event calls a Form Method (to re populate the grids base table. I found by refreshing the grid during the Form Method, everything was OK, however refreshing the grid during the timer event did not work.
Regards
Doug Johnston
>>The timer control refreshes the data in the grid every
>>3 minutes. When the timer fires, the grid goes blank
>>(grid lines etc are still there, this is not a loss of
>>control source problem), but the only way I can get the
>>grid to actually display anything is via a key press. This
>>can be any key (Delete, Insert etc).
>
>I haven't seen this problem exactly, but is this a buffered table, and is someone else entering data into the same table?
>
>Also, have you tried a DOEVENTS or INKEY(.01) instead of the keypress?
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only