Gil,

Thanks for taking the time to answer.

As for the dataenviroment, I did so, but still unsuccesful, in case I get same error again will try the exact steps you pointed out and will let you know.

As for the installation, thank you anyway, but I was talking about what MM needs to be set in order to work in a local drive against data on a network, not what VFP needs to, obviously I wasn't clear enough.

The "errorlog.dbf" table not being found problem , same that you had, started after I switched the Local Database path from my local drive to a network folder and I removed the data folder from my local drive.

As soon as I reload the application it asks me for the errorlog.dbf, apparently it is not looking for it down the local path established at metadata.dbf or the registry key, and i suspect it is still looking for it at the local drive.

Since the error gives you the chance to locate "errorlog.dbf" , I do so from the network, and after this the application is reading the data correctly.
But this is going on everytime I load the application and of course is an unwanted feature ;) at this point.

So question would be, is there any other MM file other than the EXE, classes.* , msgsvc.* to be set at the local c: drive ? In other words, do you simply put these files I mentioned (add images if you have them) in your c:\appfolder and run it for the first time to get the message where you write what are the local and remote databases ? I'd like to hear yours and others experience on this.TIA.