Yes when I opened it, the path for Core Manger was correct, but the path for Stonefield... was different, I changed it, but the file was still corrupted. I then deleted all the SDT files DBCXREG, COREDATA, SDTUSER, SDTMETA, and created a new set with SDT Explorer. Still get a problems - I actually have to go back and get the SDT.APP and recompile it before anything works. I then checked again, and it again had created the wrong directory. I tried again - putting my files on a different drive from SDT [ thay were both on G:] same problem I get G:\SDT\SDT\SOURCE\ and G:\SDT\SDT\.
However, after making the second path the same as the first. xcas2dbc runs without error. But i doesn't seem to do anything. If a change the table comments in xcase to correct a mispelling, then run xcas2dbc, the comments in SDT Explorer have not changed. If I bring up Explorer and delete a table from the list, then run xcas2dbc, the table does not get added back from the xcase model.
[I bring up VFP6, set the default to the directory where my tables, DBC and DBXCREG.DBF are located and run the following commmand:
do g:\sdt\sdt\utility\xcas2dbc.prg with 'g:\xcase\modelname\'
I think the problem is that SDT is not installed correctly the G:\SDT\SDT\ path looks wrong.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only