Walter Meester
HoogkarspelPays-Bas
Information générale
Catégorie:
Codage, syntaxe et commandes
Hi nadya,
I've not seen the entire thread, so sorry if this came up before.
If no order is set on the table where you run the SCAN from, you could use the RECNO() and RECCOUNT() parameters to display the progressbar information.
Walter,
>Hi everybody,
>
>I have a Global Replace form. In this form user may write a FOR condition. I then run a SCAN FOR command to do replace...
>
>I'm thinking about adding a progress bar... However, I don't want to count number of records prior to executing this command.
>
>I'm wondering, what can you advise here? Do you think, it would not be a much of confusion, if I would just use total number of records in the file to set maximum value of the progress bar?
>
>Thanks in advance.
Précédent
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement