General information
Category:
Forms & Form designer
Sergey,
I think this is what I will do. Because as far as I know, this is the only 'non-converted' form in the system, and it's causing more problems than it is worth. I guess that I will stick to ALL converted forms, UNTIL the client is ready to move forward with changing them all to non-converted. Back in 95 or so, I used a tool from MEI, that, if I remember correctly, stripped out all the page frames, command groups, etc, from a converted form. I've got to try to dig that thing up...
Thanks again.
>Hi David,
>
>I would create an empty form in Fox2.x, convert it to VFP and use it as a template for your new forms. Or even better, take one of the existing form, remove all controls and code and make it a template.
>
>>Sergey,
>>
>>Hi. I tried it. I get:
>>Error 1964 No PageFrame or Page is found in FormSet or Form
>>
>>PROCEDURE FRSMAINMENU1.MENUSCRN.PAGEFRAME1.PAGE1.COMMAND8.VALID F:\MYCODE
>>
>>I know that the converter creates that wacky pageframe and page thing. I don't really understand this thing which I think is called a 'read compatibility layer????
>>
>>Any suggestions? It seems like I would need to manually put in a pageframe and page, seems crazy, or, figure out a different way for the modal mainmenu form to be replaced by the form that it calls.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only