General information
Category:
Reports & Report designer
Aha ... Good to know.
However, what is really desired is for the top of the box and the sides to print on page 1 and the sides to continue on page 2 and finally the bottom.
Not asking too much huh ?
Now that I think of it ... Printing the "box" using separate "lines" for the top and sides and bottom might make this new information you have provided me, make things work. I will give it a try .... thanks.
>>I have customer who would like me to put a "box" around each detail record in a report. This detail record consists of textboxes and editboxes.
>>I can get it to work very nicely with stretches and all if I put a single line as the divider between each detail band.
>>
>>However, when I try to put a rectangle around it ... If the data spills over onto the next page, the rectangle prints on the second page completely and not on the first page at all.
>>
>>I tried building the box with a combination of 4 lines and then the 2 vertical lines act just like a box ... they print only on the second page and not on the first page when the data spills over onto a second page.
>>
>>Any ideas on how to deal with this ?
>
>
>Check the "Also print when detail overflows to new page/column" option on the box. If you don't check this option, the box only prints on the second page. If you check this option, the box prints on both pages.
>
>Cathy
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only