General information
Category:
Coding, syntax & commands
Hi Vlad,
I guess I could put the Flush after the critical table updtes. I was a little worried about slowing the system down too much but a little slowness is better than losing data.
Also, I could not find the switch for the write-behind buffering. Could you be a bit more specific. Is there any documentation on that?
Thanks, ken
>
>Use FLUSH command for this after END transaction (or tabbleupdate() if you do not have a transaction).
>
>In addition, check system settings - there is an option to switch off write-behind buffering. This will slow down the system a bit, but data writing will be much better.
>This also might be a network issue - could not help you here much...
>
>>I'm running a system on a small W98 Peer-to-Peer network (4 workstations). Not an ideal but that is what I have to work with. Thing is on two computers I have been losing data from buffered views. I haven't figured out why but think that may be a temporary or partial solution would be to flush the data to disk more often than the automatic flushing (5 minutes?)
>>
>>Can anyone give me ideas on this?
>>
>>TIA,
>>Ken
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only