General information
Category:
Installation, Setup and Configuration
I just tried it. Didn't know where to put the path, looked at the syntax, found the "of" part, and that's all I needed. Much easier than searching a drop down anyway.
Thanks!
Michelle
>Actually, you don't... you only have to add the classes it you want them to show up on the drop down. Althouhg, if you don't put them into intellesense you may need to put the full path after the word "AS".
>
>As you have seen, the Intellesense Manager only lets you add one custom class at a time. Of course, this is VFP, and the metadata for intellesense is stored in a table. You can ?_foxcode to see the name and path of this table. So, add a class manually, then look at the _foxcode table and see what values where put into what fields. I am sure then it will be a simple matter to write a little prg that gets all the classes from all the .VCX's in a directory and add them as types to the foxcode table.
>
>BOb
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only