Level Extreme platform
Subscription
Corporate profile
Products & Services
Support
Legal
Français
Network drive problem
Message
From
04/12/2002 20:22:54
Hilmar Zonneveld
Independent Consultant
Cochabamba, Bolivia
 
General information
Forum:
Visual FoxPro
Category:
Installation, Setup and Configuration
Miscellaneous
Thread ID:
00729680
Message ID:
00729718
Views:
24
>No, the setup wizard only copies the EXE. After I install the EXE on the workstation and run it, nothing happens. When I click on a menu pad, nothing. When I ran it with the data files on the local drive, everything worked fine.

OK, I was confused about the symptoms, then.

First of all, you have to make sure that the data files are accesible. You might experiment by placing the data files in the same folder as the EXE. For the final installation, you will probably want the data files in a separate folder - make sure the path is set correctly in your programs.

You also have to make sure that the forms are found. Check what form is called up by a sample menu pad. Make sure that that particular form is included in the project.

You may want to post the exact command you use on your menu pad, plus additional options (for instance, "skip for...").

Hilmar.
Difference in opinions hath cost many millions of lives: for instance, whether flesh be bread, or bread be flesh; whether whistling be a vice or a virtue; whether it be better to kiss a post, or throw it into the fire... (from Gulliver's Travels)
Previous
Next
Reply
Map
View

Click here to load this message in the networking platform