General information
Category:
The Mere Mortals Framework
I am calling the input form to call the report by using =Doform()
command like =Doform('PrintForm'). When I run this as the first thing in the project (before running any procedure). It gives me the report but if I run this anywhere in the procedure or after all the procedures. It gives me message "doform.prg does not exist". I found that it gives me error after the path is changed like set default or set path to &x.
Any help?
thanks
Bhushan
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only