General information
Category:
Forms & Form designer
Hi All,
I am trying to add a value to a property of several Sub-Classed controls on a form. I am opening the form as a table and adding the value directly to the Properties field. This is all being done by a program I created in VFP. The Class property exists. So all I’m doing is adding the value I want it to have in that field.
What is happening is that the value is being added. But when I open the form afterwards in VFP. All the controls that had been updated have all their properties reset to default. Along with the 1 property I had set. But if I open the form as a table in VFP, the changes that had been made by the program are all there. Along with all the data about the other properties.
If I open the form as a table in VFP and make the same change it works.
Any Ideas?
TIA
Mike
P.S. I am using VFP6 SP5
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only