General information
Category:
Coding, syntax & commands
Hi Gunnar
Have you tried to set a relation between the two tables then scanning through diecum .
&& set your relation here.
Select 'diecum'
GO TOP
SCAN
SELECT 'dieactualdata'
IF !EOF()
&& Do some thing
ELSE
&& There is no matching records
ENDIF
ENDSCAN
I have found in the past when I use the locate that some records where skipped. I was able to solve the problem using the set relation command then scanning through the table.
I hope this helps,
Andy
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only