General information
Category:
ActiveX controls in VFP
Hi,
This is off the subject slightly. I've known about the draw capability in VFP for quite a while, but I've always wondered, when you draw something like this in VFP, how do you print it?
I've thought about modeling software written in VFP (using draw) but I see no obvious printing solution.
Guy
>Hi Albert, glad it works for you.
>
>Just fyi - instead of all the .Line commands you could also use the .Box command. However, I prefer .Line commands because I can then either (a) not draw a particular line at all and/or (b) draw only a part of the line.
>
>I could use these two options in order to not draw lines which would not be visible in the case of a solid cube. In this way I would reduce the "optical illusion" effect of the "see-thru" cuboid.
>
>
>
>>Hi Jos !
>>
>>Your answer helps a lot.
>>Thank you very much !
>>
>>Best regards
>>Albert
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only