General information
Category:
Reports & Report designer
>I have an application that prints data on a pre-printed insurance form (UB92). Though the alignment is fine at one location / printer it is "off a bit" at another location. I cannot simply move the fields in the report because I need the report to be correct universally. Is there a way I can prompt the user (and store the data) to enter +/- beginning margins (top/left) and have the form adjust according to these parameters. Thanks in advance...
>
>
>Jamie Flick
>Micro League Software
We fought with the same problem for some time until we discoverd that the UB92 forms varied. Complained to supplier and has been much better since.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only