Jay Johengen
Altamahaw-Ossipee, North Carolina, United States
General information
Title:
Execute Code if Value Changes in Debugger
Is there a way to list/print/display the line number of code or run a procedure if a value changes during execution? I need to determine exactly when SET('SAFETY') changes from the beginning of the application to a certain point. Tracing jumps around too much and only shows you the line following the change, not helpful especially when routing through classes and such. And the call stack is not always helpful in this case either when it is sitting on a READ EVENTS.
Regards, Renoir
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only