Information générale
Catégorie:
Installation et configuration
Titre:
Setup Wizard Error 240 & Location Destination
I am trying to distribute a VFP 3.0 application. I have run into a couple of problems. First is that after completing the wizard I attempt to run the program and I get a Setup Wizard Error 240 your setup files may be corrupted.
I have search for the cause of this and I have found several errors on Setup Wizard Error 278. I have tried the few solutions found there. Namely removing the dkcontrol.*, removing links to icons within the distribution tree, and reinstalling VFP 3.0b.
So if there are any known answer for the Setup Wizard Error 240, I would be appreciative.
2nd, I need to give create the distribution so that the default installation drive is D, It takes D, but when I run the setup.exe, it is on C.
Any ideas on this would be greatly appreciative as well.
3rd, I have two icons a 16x16 and a 32x32, however when I attach either icon to the application exe, I only get that icon. I mean If it is the 32x32, the icon show up only when I am looking at large icons, if I am looking at list or detail I get the fox icon. The symptons are reversed if I attach the 16x16, this is a showstopper but it is very unprofessional. Any suggestions
Much Thanks
:-)
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement