General information
Category:
Reports & Report designer
i needed to make some programming to fill up a pre-printed form using @ SAY and SET DEVICE TO PRINTER. It fit ok to the form, but there is a problem: The dot matrix printer holds all the data in its buffer until i quit the application or send an EJECT command. Is there a command i can send to the printer to make it start printing? Something like and EOF or END OF JOB ! Any help on this would be welcomed. I tried to use LABEL FORM but couldn´t use it because i am printing in a continuos form and i found no way to make the LABEL FORM to fit in the next page, only the first goes well. I guess it´s meant to be used with single sheets.
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only