Hi Dan,

Thanks for the reply.

I am very new to Crystal. Can you provide a bit more detail please? I am not sure what you mean by "scan through." At design time, I am setting the parameter in the Select Expert for all of the reports. At runtime, I create the variable, then pass it when I call the main report. I call the report as follows:

lcCID = V_CASE.cID

If ! .OpenReport('Jacket.rpt')
Messagebox(.cErrorMessage,MB_ICONSTOP,'Report Error')
ELSE
.SetReportParameter('vp_ccase_cid', lcCID)
.Preview()
ENDIF

Thanks,

>You can scan through the report objects looking for a "sub-report" object, then set the parmeters in the sub-report just like you do in the main report.
>
>>Hello,
>>
>>I am trying to duplicate a report "jacket." When finished, the 8 1/2 X 11 report jacket, which is in landscape mode, will be tri-folded.
>>
>>There are three sections to the report. Each section is very different, so I have created three sub-reports -- one for each section. There is a left sub-report, a middle sub-report and a right sub-report. Each sub-report only contains data in that part of the report
>>
>>I have a main report and in that main report, I have shrunk every section except the Report Footer so that only the Report Footer will print.
>>
>>In the Report Footer, I have placed all three sub-reports -- one on top of each other.
>>
>>All of the reports use the same parameter field which is named: vp_ccase_cid.
>>
>>In the Select Expert, I have set the table field, ccases_cid to equal the parameter field, vp_ccase_cid. I have done this on all four reports - the main report, the left sub-report, the middle sub-report and the right sub-report.
>>
>>In design mode, I can go to the Select Expert and actually specify a ccases_cid field for each of the reports and the report prints out beautifully -- exactly like I want it!
>>
>>In runtime mode, the reports are not picking up the parameter, vp_ccase_cid, and a dialog appears asking for the parameter.
>>
>>I am not sure why this problem is occurring. I have another report (a single report with no sub-reports) where I call the parameter exactly as I have said above, and it works beautifully at runtime.
>>
>>Any idea where I have gone wrong on my report "jacket?"
>>
>>Thanks,