Mike Yearwood
Toronto, Ontario, Canada
Take a look at SET TRBETWEEN ON/OFF.
>Thanks Hilmar for your prompt reply. As you suggested, I typically use SET STEP ON prior to any debugging as I find that setting a break point is not always reliable.
>
>Which sets up my scenario:
>
>I SET STEP ON and then begin tracing. As long as I step "INTO" performance seems acceptable, but if I step "OVER" a procedure, the debugger "virtually" never returns to the current procedure. It does eventually, but I never have the patience to wait 15 or 20 minutes.
>
>The other two developers on my team are not having these symptoms. I ran a defrag yesterday and will see if I have better results today and will keep you posted.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only