hi Héctor
try 'use MyForm.scx' and look at the field 'Methods'. i have had the same problem with refox, opened the recovered form - and no code. then i opened it as a table and found the code. refox puts '*' between the procedures wich messes things up. also it sometimes did not put the correct 'end line' character on each line, so you might end up cutting and pasting into a new form.
hope this helps
>Thanks Yuri, it works, the form with its controls are back but there's no code, even a single line of it. And there was a lot.
>
>At least I recover the form, now I need to recover the code
>
>Any other idea?
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only