General information
Title:
BUG: Spinner value entry restricted incorrectly
This is reported in VFP8 because that is the version I am using.
I have a Spinner with Keyboard/Spinner High/Low values set to 61 and 360 respectively and the Value set to 75. There is no ControlSource.
Trying to enter (keyboard) the value of 300 into the control works fine except in one case - if the value area is d-clicked and then I attempt to enter the value of 300 entry is restricted to 2 characters.
Sure there are a few workarounds but it is an annoyance that user's should not be subject to.
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only