>This is in VFP7. I assume it's the same in VFP8, but I don't know for sure.
>
>I just figured out an odd problem I was noticing. "Create View" freezes the _command.prg at the state it was in when the create view was issued. When I "Set View" later on, I noticed that all the command window commands I've issued since the 'Create View' are gone. It took a while for it to hit me that this was the issue. I should point out that the commands don't disappear immediately, but the next time I bring up VFP after quitting, they are back to where they were when the create view was issued.
>
>I understand that "Set View" is used to restore a previous environment, but for some reason, it didn't occur to me that it would also reset _command.com to what it was.
>
>I find this, well... less than useful.

Hi Alan,

The help for CREATE VIEW Command doesn't mention that contents of Command Window is saved. So it's either a bug or documentation error (omission).