General information
Category:
Reports & Report designer
I have had a similar problem but the report would print to the selected printer and the printer used to create the report.
I found that if you open the report .FRX as a table, the record where the field objtype = 1, there are three memos where the printer was saved that I used to create the report which are EXPR, TAG and TAG2.
EXPR is readable where TAG and TAG2 are binary of EXPR. I just cleared TAG and TAG2 and edited EXPR and the report worked.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only