Information générale
Catégorie:
Codage, syntaxe et commandes
Titre:
Procedure Name is blank! when right click on edit window
Starting a few months ago, I started running into an intermittent problem as follows:
1) I have a large procedure file - with lots of procedures and functions
2) I am using vfp6 (sp3 - I think)
3) Sometimes, after making a number of edits to the file - I right click on the edit window - so I can popup the list of procedures and functions, and choose one to go to. The procedures and functions sort in alpha order.
4) Once in a while, upon popping up the list, I have a blank procedure name at the top of the list.
5) Upon highlighting the blank name - then clicking goto. I am taken to the 'supposedly' blank name. But the cursor is placed on the name of a valid procedure name
6) I can reproduce this, consistently, of course if I just make a procedure where there is IN FACT no procedure name like:
procedure
endproc
7) But the problem is that the procedure actually looks OK - with a valid name.
8) So, far, in the past, I have been able to fix it by deleting some of the lines for procedure name - for the offending procedure - and then retyping it again - my assumption being that some bad characters have gotten into the file.
9)Up until about a minute ago - this approach has worked. As I type this, I have a procedure file up with this problem - where it is 'resisting' my efforts to fix it by tweaking the file by deleting lines. I hope I can fix it this time. I am very worried that I have a prg file that is in some way corrupt.
Has anyone encountered this as well? Any ideas on what would be causing this?
TIA
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement