Hi All,
I haven't used the
@ clear or
@ say commmands for a few years but I had occasion to use them today. Perhaps this is an old one or has been reported before but I haven't seen it mentioned.
Version : VFP8 (Haven't tested on any other version)
Command :
@ x1,y1 Clear To x2,y2Problem : The co-ordinates x1,y1 are zero-based, the x2,y2 co-ordinates are 1-based
The same problem applies to
@ x1,y1 Fill To x2,y2. However,
@ x1,y1 To x2,y2 Scroll seems to be fine.
Is there a reason for this or is this a bug?
Regards,
Liam
Liam O'Hagan
MCP VFP Desktop Apps