General information
Category:
COM/DCOM and OLE Automation
I would like to put the visio drawing into the foxpro form and place my own set of buttons that allows the end user limited control of the visio drawing. The objects in the drawing will have a value assigned to them so when the end user clicks on the drawing FoxPro will look up that value in a table and display more information about the object.
I need my foxpro buttons showing at the same time the visio drawing is showing to create this applicaion.
I am open to any and all suggestions!
Thanks
Tim Boccaleri
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only