General information
Category:
Installation, Setup and Configuration
I don't know about VFP8, but VFP 7 requires
VFP7T.DLL
VFP7RENU.DLL
MSVCR70.DLL
I would guess that there is also a VFP8RENU.dll thay you are missing. Do you create a setup disk to install the application? I don't know if VFP8 Dlls must be registered or not but that may be the problem. Normally these dlls reside in the windows system or system32 folder. A setup would properly register any required dll.
Hope this helps.
>I have a small application that I want a user on the network to use and I have copied the runtime files (msvcr70.dll,gdiplus.dll,vfp8r.dll,vfp8t.dll) to the same directory as the EXE and DBF/DBC.
>
>The application runs fine from my machine, but not from a machine without VFP. It says "VFP cannot start. Could not load resources"
>
>What else do I need to have in that directory to allow someone to run that EXE?
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only