General information
Category:
Reports & Report designer
>My DE is empty.
>
>Your suggestion of setting a breakpoint on USED("TempSort") would always return .t. since it is supposed to be open. I tried setting a breakpoint on Alias() just before the report was called, but it did not change until after the report preview was closed. It still used the wrong cursor. Below in the code that immediately preceeds calling the report:
>
>select curReport
>index tag curReport on RType+ltrim(Str(lot))
>go top
>report form receiving to printer prompt preview noconsole
How do you refer to your table fields in your report? As MyTable.MyField or as MyField only? Can you open the Data Session window while you are previewing the report (just to make sure, be on one of the middle lpages) and see what's in the current work area?
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only