General information
Title:
SDT - Can't Change Field Type from AutoInc
Hi Doug,
I have a new table I created with SDT 6.1b. It has an iKey field which is set to AutoIncrement. I needed to manually adjust some of the keyfield values, so I tried to set the data type back to integer. Even though it appears to accept the change, the change isn't "taking". I had to use "modi stru" to make the change. I made the manual change to the key field, then set it back.
I figure that this is either by design (I can imagine some awful consequence of changing the field type from autoinc), a defect, or perhaps most likely, an ignoramous user.
What do you think?
Thanks,
David
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only