>Hi Terry,
>
>Did you try to install on some other PC to make sure that the problem is not with setup itself?

Howdy Sergey,
I dod not install VFP 6, but I did install the SETUP.EXE that VFP 6 generated. I did a test install on my system - And I got a "could not run" error on S32NAVQ.DLL. I installed on 4 Desktops at the clients and got the same message.

I checked google and found http://groups.yahoo.com/group/freds_virusinfo/messages/2301?viscount=100

There are a couple of messages starting at 2358 about S32NAVN, but nothing about "Q". The only time I have used norton stuff is when I download emergency scan software - like the NIMDA scanner.

I am thinking I will uninstall the VFP 6 service pack and then reinstall.

I have looked at the VFP 6 SETUP "reports", but it lists files, and doest seem to indecate anything about an executable. The mesaage I get is at the very end of the setup install - almost like I asked the wizard to run an EXE after SETUP was complete.


>
>>It's been a while - but a VFP 6 project SETUP.EXE (webapp.exe) was created. I did a test install on my system.
>>
>>Setup report it could not run a program because S32NAVQ.DLL (yes - there is a "Q" in it) could not be located. SETUP then informed me that the install was not complete. However, the group and program showed up on the "Program" menu and the program well.
>>
>>The last time I experienced this, I thought it was due to a Norton Anti Virus sniffer on the clients desktop. I don't have norton. I did download nortons NIMDA scan (way back when) to check my system.
>>
>>I googled on S32NAVQ, and google returned "did you mean S32NAVN?". I accepted and was forwarded to info about a "love-gate" virus?
>>
>>Any ideas on how I can remove this?
>>
>>Terry