General information
Category:
Coding, syntax & commands
>>Sawadee,
>>
>> I have a problem with table alias' not found when issueing a do form.
>>I have an interface that has controls in it to launch various forms. It also has a combobox to select items that will change the forms that the controls will launch via a form name prefix cfgVariable. The comboBox is loaded by scaning a tableA, then the prefix is set by seeking in the same tableA to the record that matches the current value in the comboBox. The interface works fine until I use the comboBox to select a new tablename prefix. Thereafter, I get cannot find alias messages when do form is issued. What do I have to do after using the table that sets my tablename prefix? I've tried closing all tables and/or reselecting the work area that was active before using the comboBox. I'm thinking that opening the tableA is somehow causing the next form I run to not find the correct alias.
>>
>>Eric K.
>Eric couldn't understand well. Do you mean alias by prefix or something like it ? If so I think the problem could be you don't trim the combobox value and it's something like "value " instead of "value".
>Cetin
Cetin,
It can't find the alias for the data environment of the form.
Also, I trim everything to be sure.
Eric
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only