Jay Johengen
Altamahaw-Ossipee, North Carolina, United States
Jay Johengen
Altamahaw-Ossipee, North Carolina, United States
General information
Category:
Forms & Form designer
Sorry, I put this in the wrong area.
Also, I was able to make this work by setting the page to 11 x 17 before the paste, moving the block to the left and setting it back to 8.5 x 11. Seems like something that I shouldn't have to do though.
Renoir
>I need to revise a number of reports with a block of various objects. When copied/pasted from the source report to subsequent reports it offsets by an amount that cause it to run past the right margin. This in turn causes the objects to realign themselves to fit within the margin. This messes up the location of the objects within the block. I then have to go into the copied objects and reposition them to be like the original. Defeats the purpose. I could not find a setting to change the offset to zero - what I really would prefer - but thought I just wasn't looking in the right place. Any ideas? Thanks!
>
>Regards, Renoir
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only